Antique Drill

The drill hole diameter is 1.6 mm. In the fourth set of bow beads to the back, the longest is 1.83 cm in length.

Width- 4.3 mm. Diameter of drill hole-3.2 mm. A straight cylinder alabaster bead.

The drill hole diameter is 2mm. The quartz bead in the slide is 1.18 cm in length, 1.2 cm in width, 4 mm in thickness and has a drill hole diameter of 2.5 mm.

The longer tapered tubes have drill holes of 1 mm; the shorter more cylindrical ones have drill hole diameters of 1.5 mm.

The center bead is a tabular etched carnelian 1.7 cm in width, 6.2 mm in thickness at the center and tapering to 3.6 mm thickness at the edge. The drill hole is 2.5 mm in diameter. T...

Width 6 mm tapering slightly to 4.5 mm at the ends. The diameter of the drill hole is 3mm. The bead was drilled from each end and the holes are off set where they meet in the middle.

The drill holes are large, 4 mm and tapering slightly towards the middle.

Probably based on earlier Indus Valley beads made from softer materials, these agate versions were made possible by technological innovations in drilling that allowed long holes to b...

The drill hole diameter is 3.5 mm. The final bead on the left side of the necklace is 1.8 cm in length, 9 mm in width at the ends and has a drill hole diameter of 2mm.

This gorgeous, massive hand-painted ceramic pot believed to be from the Netherlands with hand- painted shade is an amazing statement piece in any room. Pot is not drilled and can be ...

The holes have been drilled from each end. They do not meet in the center.

The drill hole diameter is 2.75 mm. The ends are slightly angled from wear.

The ends are slightly squared off to give a flat surface for the hole. The drill hole is 3mm in diameter. There is some chipping at the shoulders of the drill hole.

The beads and pendants were all shaped without the use of metal tools, the holes being drilled with bow drills and abrasives, the forms being cut with string saws and abrasives and t...

Four thousand years ago, beads were drilled with stone bits that were turned with bow drills.

In very good condition, our chandelier has been drilled for electricity. This charming and very elegant model is decorative and easily integrated into a decoration that is both conte...

The center bead is a rounded, long barrel-shaped bead, 1.5 cm in length, 6mm in width at the center, and 4 mm in width at the ends. The drill hole diameter is 1 mm. To the left is ...

The bead is 2.5 cm in length, the width is 2.63 cm, the thickness is 7.1 mm and the drill hole is 3 mm. The lapis beads are short cylinders with rounded edges 6.8 mm in length, 8 mm ...

This is the result of very thin walls at the edge, the result of having a very large drill hole. Beads with drill hole diameters of 3 mm and more are very early, from before the inve...

The inscription on the pewter mount reads "Chiswick Volunteer Fire Brigade 1881 First Prize Hydrant Drill J W Dore". J W Dore died in 1904, aged 47, apparently still active in the Ch...

Multi vibrant colors. Not drilled.

The largest at the center is 5.5 mm in length, 4 mm in width and has a drill hole diameter of 1 mm. The carnelian beads graduate in size towards the back.

The shorter ones are thickest, 3.75 mm and the longer one are thinner, at 3 mm in width. The drill holes are 1.25 mm – 1.5 mm in diameter. The drill holes are one straight bore from ...

The round beads range from 7.8 mm to 4 mm in diameter. The diameter of the drill holes is 2 mm. The agate barrel beads range in size from 1 cm in length, 6.5 mm wide and a drill hole...

The drill hole diameter is 3 mm. The long carnelian bead to the left , the second one back, is 3.25 cm in length, 8 mm in width and with a drill hole diameter of 3.8 mm.

Images (of inside and of outside of chrysanthemum base) show hole drilled for lamp-cord.

The largest are 8 mm in length, 6.5 mm in width, and with drill holes of 1.6 mm in diameter. The smallest are 5.2 mm in length, 4.5 mm in width, and drill hole diameters of 1.6 mm.

A gold tube has been inserted at the drill hole. The sides are slightly in curving. 13.

The bow is adorned with sparkling foiled garnets and natural sea water pearls. The pearls are drilled and wired to the body of the necklace using a thin gold wire (typical of Sicilia...

Pair of four-arm black and gilt bronze sconces with scrolled arms and decorative backplates. Drilled for wiring.

The poppy seed pod pendants are 1.2 cm – 1.35 mm in height and 5 mm – 5.9 mm in width. The drill hole diameter s are 1.2 mm. The round carnelian beads are 4 mm in diameter and have d...

The thickness at the center is 9.8 mm. The diameter of the drill hole is 2.5 mm. The smallest double drilled bead at the back of the necklace is 1.6 cm in height, 5 mm in width and 7...

The figure is 1.5 cm from chin to back. It is drilled through the neck for suspension. The drill hole is 3 mm in diameter at the surface and tapers inward.

The pendant is a cone with a domed base and is drilled through the side at the pointed end so that the wide part hangs pendant.

It is 1.65 cm in height, 1 cm in width at the widest point and 4.5 mm in thickness. The drill hole diameter is 1.5 mm. The carnelian poppy seed pod amulets are 1.5 cm in height, 6 mm...

It is 1.55 cm thick, from from to back. It is drilled through at the neck for suspension; the drill hole is 4 mm at the outside and tapers towards the center.

The drill hole is 3 mm in diameter. The back is flat.

The pendant is 2.82 cm in height, 1 cm in width at the bottom. The drill hole is 4 mm from the top and is 2.3 mm in diameter.

Beautifully weathered and in good condition, the base drilled for drainage, but can be made watertight if required.

The lapis bead at the center is 2.33 cm in length, 4 mm in width and has a drill hole diameter of 1.8 mm. The gold band is 5.5 mm wide.

19th century urn carved with stiff leaves raised on circular foot, drilled and mounted as a table lamp.

At the center of the necklace is an onyx lozenge shaped bead 1.15 cm in length, 9 mm in width and 3 mm in thickness. The diameter of the drill hole is 1.8 mm. The onyx barrels are ve...

Lobed urn carved with stiff leaves raised on circular foot, drilled and mounted as a table lamp.

Turquoise is a soft stone and it was utilized early on for bead making as it can be shaped and drilled using flint drill bits and bow drills. But this also means that over time the s...

Well chased all around in various low relief patterns. Not drilled for drainage. The opening at the top measures 15.75 in diameter and it is 18 deep.

Each lobed urn carved with leaves raised on plinth base drilled and mounted as a table lamp.

Thirty-three diamond shaped double-drilled lapis lazuli beads each of which is separated by two groups of four small carnelian beads with a lapis lazuli bead in the center.

A ribbed cylindrical antique Japanese Imari vase, drilled and mounted as a lamp. Bold design in blue, orange, yellow, green and black.

It is 2.5 cm in height and 1.2 cm wide, and 1.63 cm from back to front. It is drilled similarly to the others with a 4 mm diameter drill hole.

The ends taper to 2 mm with the drill hole diameter being 1.6 mm. The fish is rounded on the front side with a flat back.

It is 9.25 mm wide at the shoulders and it is 6 mm thick at the middle; the backs of the head and legs angle forward on the back side. It is drilled through for suspension at the nec...

An interesting antique wooden final that has been drilled and wired as a lamp. The total height of the carved urn less the metal parts is 23 inches.

Length 1.48 cm, width at center 1.1 mm, width at ends 6.9 mm, diameter of drill hole 3mm. (3.) Bow bead length 3 cm, height 1.8 cm, height of center section 1.42 cm, width at ends 5...

Wrought iron martini tables, hand made in England inspired by an original 1940s French design. Finished with a natural bronze patina as standard. Can also be supplied in black or gi...

- A fabulous run of church opaline acorn pendant lights with steel galleries, circa 1950. - Wear commensurate with age, all in excellent condition, the steel galleries are aged worn...

The Sasco is a versatile custom-made solid brass and glass globe light fixture, which can be mounted on the ceiling or wall. Shown here in our factory brass, an uneven unfinished br...

A Classic Empire style grey cerused oak oatmeal stained center table with a carved ogee edge, raised on an octagonal pedestal base. Dimensions: 42" W x 42" D x 30" H. Clearance: 27"

Hans-Agne Jakobsson 'Mini-Tratten' verdigris patinated outdoor sconce. An exclusive made for U.S. and UL listed authorized re-edition of the classic Swedish design executed in rich v...

Pair of Murano glass wall sconces, in stock Fume color and horizontal striation texture Black opaline finials and brass accents Art Deco inspired design. Gives off warm beams of lig...

Petite sconces from Murano, Italy made with smoked glass stamped into a lovely curved shape with texture. The brass structure has been newly wired to fit US standards. This pair is...

A charming and rustic set of 10 dining chairs in pine and seagrass seats. Made in the 1960s by a Danish cabinetmaker. A fine mid century brutalist set that pairs well with many type...

This Art Deco rectangular mirror, crafted in America circa 1935, is a stunning example of the opulent and meticulously detailed design that defines the Art Deco movement. The mirror ...

Frank Lloyd Wright designed wooden "Robie 2" coffee table in walnut stained cherry. The highly influential Wright created this coffee table in 1902 for his Frederick C. Robie House i...

Exceptional and rare sculptural Amsterdam School side table, executed in solid mahogany (a non restricted type for US shipment) and dating from the early 1920s. This piece is a stri...

Clean Lined Art Deco Bookcase, designed by Gilbert Rohde for Herman Miller, American, circa 1930s. Part of Rohde's modular East Indian Laurel Group. This piece is currently being ref...