Airplane Wing

Man then wants to fly and designs and uses airplanes, wing suits, hang gliders. Here I simply use them for a petite 18 mm high x 6 mm wide {5/8ths x 3/16ths inch} ribbed earring.

Flying wing airplane model with engine. For decoration only.

This exceptional oversized dining table has a perfect and fluid design with amazing airplane wing movement at its edges and a fabulous striped walnut wood, with a beautiful and sober...

Sculptures made of translucent polyester stretched on shaped frames, these pieces hark back to Metcalf’s early fascination with the spatial dynamics of fabric stretched over the fram...

Sculptures made of translucent polyester stretched on shaped frames, these pieces hark back to Metcalf’s early fascination with the spatial dynamics of fabric stretched over the fram...

Sculptural paintings made on translucent polyester stretched on shaped frames, these pieces hark back to Metcalf’s early fascination with the spatial dynamics of fabric stretched ove...

Early and rare test model of an airplane Wind Tunnel Bi-plane. This model was used to find out the flying ability of the aircraft's design. Hand made from wood with steel components...

Modern Wall Art? A rare section cut from a authentic WWII DC-9 wing tab. It has been cleaned and painted professionally with high gloss yellow powder coat paint. Its 17" wide, ...

Achieving simple shapes in a range of gray tones through applications of acid on the plate, the artist directs one’s eye to the basic geometry of the markings on the airplane wing. ...

Achieving simple shapes in a range of gray tones through applications of acid on the plate, the artist directs one’s eye to the basic geometry of the markings on the airplane wing. ...

Achieving simple shapes in a range of gray tones through applications of acid on the plate, the artist directs one’s eye to the basic geometry of the markings on the airplane wing. ...

Achieving simple shapes in a range of gray tones through applications of acid on the plate, the artist directs one’s eye to the basic geometry of the markings on the airplane wing. ...

Achieving simple shapes in a range of gray tones through applications of acid on the plate, the artist directs one’s eye to the basic geometry of the markings on the airplane wing. ...

Unique 21st century desk designed as the extended piece of an aluminum riveted airplane wing. On three metal strut shaped legs.

Modern industrial silver “airplane” wing writing desk table for the home or office.

Anne Sager (American, 1930-2024), Airplane Wing, Chromogenic Print, with artist's estate stamp to verso, unframed.

Wimbledon-Furniture Wimbledon-Furniture is delighted to offer for sale this hand made airplane wing dining table known as the Mosquito Table designed by Sir Terence Conran and was m...

Desk made from an airplane wing

.SOLD NOVEMBER 2010...Peter Hamburger's exquisitely modern form in extruded shaped lucite and chromed metal "airplane wing shade". Sensous, modern lighting sculpture.

A heavy stainless base supports the bundle, beginning in a thick profile similar to an airplane wing, twisting subtly as it rises and flattens at the top, again beautifully joined wi...

It is a high-end piece of cabinetry with airplane wing edges and a slender but very sturdy base.

This Designer Pendant Light was inspired by the frame from an airplane wing. It's the ultimate in modern lighting.

Crafted in solid oak, it features four sliding doors and two front drawers with sculptural, airplane wing-shaped handles. The panels are finished in textured black and grey laminate,...

During WW II, Howell made bombs and shells along with airplane wing sections and with the war ending went back to making their steel furniture.

Their aerodynamic shape is inspired by the shape of an airplane wing. The top is made of plywood and is covered with authentic aluminium sheet.

In the box are an additional set of airplane wings in case you want to convert it into a bi-wing airplane.

Unique and very rare mixed-metal wall sculpture of three bi-wing airplanes over an airfield by Curtis Jere for Artisan House, circa 1970s.

His boards evolved over the years from designs with hundreds of holes drilled into it covered with a thin wood veneer, to a design with carved chambered out hulls, to finally a much ...

Today, the Wright Flyer III is displayed at the Dayton Aviation Heritage National Historical Park in Dayton, Ohio. It is the only fixed-wing airplane to be designated a National Hist...

Today, the Wright Flyer III is displayed at the Dayton Aviation Heritage National Historical Park in Dayton, Ohio. It is the only fixed-wing airplane to be designated a National Hist...

Unique 21st century desk designed as the extended piece of an aluminum riveted airplane wing. On three metal strut shaped legs.

Funky four vintage car ornaments made of chrome, cannot be mounted on car anymore, however drilled and made available to use as decorative wall hanging in few deferent combination, s...

Interesting three vintage hood car ornaments made of chrome, can not be mounted on car anymore, however converted to decorative wall hanging, some oxidization.

Attributes to Maison Regain, minimalist lines with airplane wing top.

Light weight and strong (like an airplane wing). All fastened with small copper and brass nails.

This designer pendant light was inspired by the frame from an airplane wing. It's the ultimate in modern lighting.

The image depicts the same scene showing an airplane wing and the ground below, but the scene changes dramatically with the different colors used for each state.

The printed signature is visible in the left bottom corner, just below the airplane's wing. Condition: Overall very good condition.

His boards evolved over the years from designs with hundreds of holes drilled into it covered with a thin wood veneer, to a design with carved chambered out hulls, to finally a much ...

His boards evolved over the years from designs with hundreds of holes drilled into it covered with a thin wood veneer, to a design with carved chambered out hulls, to finally a much ...

Today, the Wright Flyer III is displayed at the Dayton Aviation Heritage National Historical Park in Dayton, Ohio. It is the only fixed-wing airplane to be designated a National Hist...

section of an aluminum airplane wing

Cross section of an airplane wing model depicting the various applications involved in aircraft construction.

Nice machine age sculpture, warning light at tip of the wing functions as atmospheric light

Skinned Cessna tail wing half with custom light.

Pair of structural wing cross section models. Made of cedar wood and mahogany with varnish sealer. Great on a wall. Signed Albert Matuschak from Seattle.

Walnut bench upholstered in sand Rogers & Goffigon waxed linen. Orders for COM and custom sizes available, upon request.

This desk is made from a section of wing from a WWII US Army Air Corp DC-3 It has a acrylic top with a silver powder coat paint finish.

Awesome "airplane wing" desk, in mahogany with black border. fitted with 4 drawers on right & 3 drawers on left.

Arms have a thin side taper, almost like an airplane wing. Cushion supports are individually oval-shaped wooden dowels.

This wonderfully constructed dining table is built like a airplane wing. The table is incredibly strong and super light.

Spectacular and unique luxury desk made out of an original DC-9 Aero California airplane wing.The top is covered by a 10 mm thick glass .

A beautiful set of 9 airplane wing-shaped shelves in solid Rio rosewood and veneers, which hang without tools from dark brown metal uprights.

The aluminum body was constructed like an airplane wing at the Sargent Fletcher Company of El Monte, California.

The aluminum body was constructed like an airplane wing at the Sargent Fletcher Company of El Monte, California.

The aluminum body was constructed like an airplane wing at the Sargent Fletcher Company of El Monte, California.

The "Solana" wall mount sconce or reading light is strongly influenced by Scandinavian, Danish, French, and Italian Mid-Century Modernism. The walnut back plate (available in natural...

Paolo Buffa (1903-1970) Rare and very elegant wooden daybed Varnished walnut and fabric Model created circa 1940 H 58 × L 205 × W 95 cm Paolo Buffa was an Italian furniture des...

This sideboard cabinet, crafted in the 1960s by Alberto Salvati and Ambrogio Tresoldi, is a prime example of how neoclassical design principles were incorporated into midcentury Furn...

Amuneal's Brass Pantry Cabinetry, part of our metal Kitchen Collection, is designed as a feature element for any space. The three doors on the upper cabinets are fabricated with a kn...

Carousel suspension lamp has a delicate balance of form and function that produces a quiet, modern light ambiance for all to savour, with its Contemporary Art Deco lines. The struct...

Introduce monumental elegance and a grounded detail to your interior with the stunning pink  marble CONE side table. The sculptural geometric shape of this contemporary design piece ...

Art Deco table lamp with nickel finish and glass rods.

Splendid bright green Murano glass mirror. A mirror that alone will furnish your home environment. Rich but tasteful, the mirror has a truly particular design, with a very beautiful ...

A rare floating console and mirror (No6652) by Osvaldo Borsani designed for Casa Ramella Levis 1946 . Executed in gilded wood, marble and mirror a seamless hand carved looped coil a...

COD-2534 Paolo Buffa (1903-1970) Rare walnut bar cabinet with maple inlaid front and lacquered metal interior. Two maple drawers with glass fronts, mirrors and hidden light. Drawing...

Large tall Pair of white penerello Murano glass and brass wall lights lightning pannel lamps sconces. Contemporary work from a small artisanal italian design workshop. In the mood of...

Conference table, made from original structure of Boeing Bi-Plan Wing from 1934. Original brand new piece made on order. With top in thick clear glass. Exceptional piece.