Midcentury Teak King Platform Storage Bed and Nightstands

A beautiful Scandinavian Modernist, teak Danish table/ nightstand by Danflex Systems made in Denmark, circa 1970’s, elegant design with clean straight lines making it a sleek, minima...

Extraordinary pair of Mid-Century Modern double door cabinets /nightstands by Lane Furniture. This retro pair was constructed with top-of-the-line hardware, and excellently crafted w...

A remarkable pair of mid-century nightstands, end tables by Harvey Probber. These absolute jewels remain in nearly pristine condition. The lines are clean and elegant with exceptiona...

A beautiful mid-century nightstand/end table with cane front drawer panel. Exceptional construction and style. This is a very simple yet modern design. Features beautiful walnut medi...

The patinated finish on the Mossam Bed is meticulously developed to enhance the bed's industrial charm while infusing it with an air of time-worn allure. The patina lends a distincti...

The western bed is an original design that draws on the tradition of Mid-Century Modernism and Danish sensibilities. It's a statement of clean lines, simp...

A generously proportioned platform bed by California designer and woodworker Gerald McCabe for his company, Eon Furniture. This example is solid maple with two drawers for storage at...

This piece is designed and hand-crafted by yours truly in Long Beach. The bed pictured is built from walnut, but I can use other woods upon request. The design is my own, inspired by the Scandinavian furniture of the 50's (Danish/Mid Century Modern). All joinery is mortise and tenon, which means it's strong and built to last forever. The price listed here is for a queen bed (frame alone is 65" by 85"). We can make this a king or full as well. The bottom of the bed is 8 1/2 inches off the ground, and the top of the headboard is about 39 inches off the ground, and there's about 13 inches from the top of the slats to the bottom of the headboard* (see note below). The mattress rests on slats, and I can put a thin sheet of plywood over the slats to give a uniform, platform-like surface upon request (some folks prefer just the slats- depends on your mattress). It has four drawers underneath, two that slide out on each side (in the picture there are only two long drawers that slide out to either side of the bed, I have since switched to four drawers). Each drawer is approximately 6 inches tall, 29 inches wide, and 27 inches deep** My design approach on the drawers is to keep them recessed behind the edge of the bed, and to have them floating off the ground, so that visually the bed does not feel bulky like most storage beds...