Skip to main content
Want more images or videos?
Request additional images or videos from the seller
1 of 13

C. 1948 Set of 4 Evans Herman Miller Eames DCW Dining Chairs in Calico Ash

$6,000per set
£4,490.68per set
€5,199.93per set
CA$8,339.02per set
A$9,392.55per set
CHF 4,864.07per set
MX$114,068.84per set
NOK 61,784.89per set
SEK 58,608.18per set
DKK 38,798.60per set
Shipping
Retrieving quote...
The 1stDibs Promise:
Authenticity Guarantee,
Money-Back Guarantee,
24-Hour Cancellation

About the Item

This is a set of four DCW Dining Chairs in Calico Ash, initially designed by Charles and Ray Eames in 1946. These are ultra-rare, early examples that were produced by the Evans Plywood Company circa 1948. One chair retains its original Evans label. One chair was previously drilled through the panel panel, however, we had it sent out to a master woodworker, who did an inlayed veneer repair that makes it barely visible. The other three chairs were untouched. Each chair measures 20.5 inches deep, 19.5 inches wide, and 29 inches high. Their seat height is 18 inches. There is a patinated finish on the wood that gives a nice definition to the grain. There is some age evident on the original screws and hardware, and there is some fading to the finish of the seats. Overall, this important set is in good vintage condition with some signs of time. Please see photos. Genuinely faulty goods will be replaced or money refunded on a case by case basis, however we must be advised of any faulty goods upon receipt of the item. It is the customer's responsibility to pay for return shipping and ship the item back to us. If the item is found to be faulty, we will also refund the postage cost. If there is no damage to the item, but a return is approved, the buyer will be responsible for both the initial and return shipping cost. It is at our discretion to refuse the refund of undamaged goods. If an order is placed and you would like to cancel the order, please notify us immediately. Any refunds will be processed via the same means that payment was made.
  • Creator:
    Charles and Ray Eames (Designer),Herman Miller (Manufacturer)
  • Dimensions:
    Height: 29 in (73.66 cm)Width: 19.25 in (48.9 cm)Depth: 20.5 in (52.07 cm)
  • Sold As:
    Set of 4
  • Style:
    Modern (In the Style Of)
  • Materials and Techniques:
  • Place of Origin:
  • Period:
  • Date of Manufacture:
    1948
  • Condition:
    Wear consistent with age and use.
  • Seller Location:
    Philadelphia, PA
  • Reference Number:
    Seller: 220726071stDibs: LU8164240515022

More From This Seller

View All
C. 1954 Set of Four Herman Miller Eames DCM Dining Chairs in Calico Ash & Steel
By Charles and Ray Eames, Herman Miller
Located in Philadelphia, PA
This is a set of four DCM Chairs, originally designed by Ray and Charles Eames in 1946. These pieces were produced by Herman Miller in the USA C. 1954. Their design features a bent-p...
Category

Vintage 1950s American Modern Side Chairs

Materials

Steel

1946 Pair of RARE Evans Eames Herman Miller DCW Dining Chairs in Calico Ash
By Charles and Ray Eames, Evans Products Company
Located in Philadelphia, PA
This is a pair of DCW Dining Chairs in Calico Ash, originally designed by Charles and Ray Eames in 1946. These are ultra-rare, early examples that were produced by the Evans Plywood ...
Category

Vintage 1940s American Modern Lounge Chairs

Materials

Steel

1948 Eames for Evans & Herman Miller Set of Six DCM Dining Chairs w/ Provenance
By Charles and Ray Eames, Evans Products Company
Located in Philadelphia, PA
Listed for sale is one of the rarest and best documented sets of Eames DCM chairs in existence. First and foremost, it is a set of six original matching maple DCM dining chairs, prod...
Category

Vintage 1940s American Modern Dining Room Chairs

Materials

Wood

1948 Eames Evans for Herman Miller DCM Dining Chairs Metal & Walnut Set of Five
By Evans Products Company, Charles and Ray Eames
Located in Philadelphia, PA
Listed for sale is an original set of five DCM chairs, designed by Charles and Ray Eames. This particular set dates to approximately 1948 and was produced by Evans plywood company (the earliest manufacturer of these chairs). Notable also is that they were specified in Walnut, which contrasts the metal legs beautifully. These chairs retain their original feet, shock mounts (some may have been replaced during their lifetime), and screws. The walnut panels may show some wear. Please see photos. Their Evans production can be confirmed based primarily on the feet and headrest connection. Only early Evans examples had this round, circular detail connecting the backrest to the frames. Please note that the chair frames have not been cleaned, as some collectors prefer fully original examples. If requested, we can certainly clean the frames to remove the oxidation noted in the photos. Another set of four Evans DCM...
Category

Vintage 1940s American Modern Dining Room Chairs

Materials

Metal

1946 Pair of Eames Evans DCW Dining Chairs in Calico Ash Wood
By Charles and Ray Eames, Evans Products Company
Located in Philadelphia, PA
This is a pair of DCW Dining Chairs in Calico Ash, originally designed by Charles and Ray Eames in 1946. These are ultra-rare, early examples that were produced by the Evans Plywood ...
Category

Vintage 1940s American Modern Side Chairs

Materials

Steel

1960s Set of Ten Herman Miller Eames DCM Dining Chairs in Brazilian Rosewood
By Charles and Ray Eames, Herman Miller
Located in Philadelphia, PA
These are Eames DCM Side Chairs, initially designed by Charles and Ray Eames in 1946. These examples date to the 1960s. The listed price includes the set of ten chairs as shown. Thei...
Category

Vintage 1960s American Modern Side Chairs

Materials

Steel, Chrome

You May Also Like

Set of Four Early Eames Dining Chairs
By Charles and Ray Eames, Herman Miller
Located in Cambridge, US
USA, ca. 1950s. A rare and early group of four DCWs (Dining Height / Side Chair / Wood Bases) by Charles & Ray Eames. Each features signature molded plywood construction finished wit...
Category

Vintage 1950s American Mid-Century Modern Dining Room Chairs

Materials

Ash, Plywood

Set of 6 Charles & Ray Eames DCW Dining Chairs for Herman Miller in Ash
By Charles and Ray Eames, Herman Miller
Located in Port Jervis, NY
Fabulous set of six DCW chairs by Charles and Ray Eames for Herman Miller c1985. Created from Ash and show a striking grain pattern in the backs and seats particularly. In excellent...
Category

Vintage 1980s American Mid-Century Modern Dining Room Chairs

Materials

Ash

Set of Four Herman Miller Eames DCM Dining Chairs
By Herman Miller, Charles and Ray Eames
Located in Brooklyn, NY
Vintage Herman Miller Eames DCM dining chair set. Executed in ash and chrome steel bases. All screws and self leveling glides intact. In even condition with...
Category

21st Century and Contemporary American Mid-Century Modern Dining Room Ch...

Materials

Steel

Set of 4 First Edition Eames Evans DCM Chairs
By Charles and Ray Eames
Located in Seattle, WA
Four Early DCM chairs designed by Charles & Ray Eames for Evans, distributed by Herman Miller. Labels remain intact on all four chairs. Shock mounts has been...
Category

Vintage 1940s North American Mid-Century Modern Dining Room Chairs

Materials

Plywood

Early Eames DCM Birch Plywood Dining Chairs
By Charles and Ray Eames, Herman Miller
Located in Brooklyn, NY
Nice set of early 1950s DCM chairs, designed by Charles and Ray Eames for Herman Miller. These are well-preserved second generation examples in a fetching birch and black combinatio...
Category

Vintage 1950s American Mid-Century Modern Dining Room Chairs

Materials

Metal

Early Eames DCM Birch Plywood Dining Chairs
$3,250 Sale Price / set
50% Off
Eames Herman Miller DCM Chairs in Walnut and Black Frames
By Charles and Ray Eames
Located in Dallas, TX
This is a set of four DCM Chairs, originally designed by Ray and Charles Eames in 1946. These pieces were produced by Herman Miller in the USA in the 1950s. Their design features a b...
Category

20th Century American Mid-Century Modern Dining Room Chairs

Materials

Steel